6
Z-8 : 10 meter wired remote controller can operate the Z-1200.
Its three knobs allow the operator to customize fog machine functions
by adjusting output duration, interval and output volume.
1. Adjust the duration of each fog emission (within the range
of 1 to 15 seconds) by means of the DURATION control knob
2. Adjust the interval between each fog emission (within the range
of 10-255 seconds) by means of the INTERVAL control knob.
3. The volume of fog produced is regulated via the OUTPUT knob. This
varies between 0 and 100% of maximum volume output.
4. Press the yellow TIMERS button to activate the timer function.
5. Press the red CONTINUOUS button for continuous output.
6. When pressed, the green MANUAL button overrides all other
function controls, and activates maximum output.
Installation
Installing the Fogger
Remove all packing materials from the fog machine. Check that all foam and plastic padding is removed,
especially in the nozzle area.
Fill with Fog Liquid (ordercode 60603) or other high-quality water-based fog fluid. Any other types of fluid
can damage the unit. When filled, place cap back on liquid tank.
Firmly attach the remote control cable to the proper input on the rear of the machine
The unit can also be operated at floor level or sitting on any regular surface as well.
If the unit is to be mounted using the bracket, it is important that the fog does not shoot directly at any one’s
face. Therefore, do not point the nozzle in a direction that will aim directly at a person.
Whatever installation method you choose, do not allow the unit to have more than a 15 degree angle of
inclination.
Always disconnect from electric mains power supply before cleaning or servicing.
Damages caused by non-observance are not subject to warranty.
Set Up and Operation
Before plugging the unit in, always make sure that the power supply matches the product specification
voltage. Do not attempt to operate a 120V specification product on 230V power, or vice versa.
Procedure :
1. Plug power cord into a grounded electrical outlet. If necessary, turn power switch on rear of unit to “ON”
position. Warm-up is complete when green lamp lights up on remote unit..
2. To emit fog, press the button on the remote and hold for the desired length of time.
3. The remote unit’s lamp will cycle on and off as the machine re-heats to the proper operating temperature.
4. For further information on operating your Antari Fog Machine, see Remote Control Operation.
Remote Control Operation
1 2
3
4 5 6 Fig. 2
Optional Remotecontrol : Z-9: Wireless remote controller
(48 pages)
(44 pages)
(16 pages)
(13 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commentaires sur ces manuels